Abstract

Recently in Japan, noises from wind turbines and domestic use heat sources sometimes cause an increase in noise annoyance owing to low-frequency tonal components. The purpose of this study was to investigate the effects of the tonal components on the annoyance of the environmental noise. The authors conducted an auditory test in the laboratory to evaluate the annoyance of tonal noise using a seven-step rating method. The stimuli were composed of a broadband noise modeling of the environmental noise (25, 30, and 35 dB) and a low-frequency tonal component. With the tonal component added to the broadband noise, the frequency and tonal audibility were varied to 40, 50, 100, 200, and 400 Hz and 0, 3, 6, 9, and 12 dB, respectively. The amount of increase in annoyance owing to the addition of the tonal component was quantitatively evaluated as a tonal adjustment by comparing it with broadband noise. As a result, tonal adjustment ranged from 0 to 7 dB, and the higher the tonal frequency, the larger the value. For the test background noise level, the lower the background noise level of the test sound, the greater the value. This trend suggests that the influence of tonal components on subjective impressions is stronger in quiet environments such as residential areas. This result may provide a basis for the evaluation method, which varies the penalty in the noise evaluation according to the frequency of the pure tones and the noise level.

Highlights

  • Tonal noise contains a prominent narrowband component

  • In view of this fact, the tonal noise problem may be problematic in Japan, and the manual requires the measurement of tonal audibility (TA) according to the guidelines of foreign countries

  • A total of 439 cases of noise with LA between 40 and 80 dB were evaluated for their effect on annoyance, and the results showed that the presence of tones increased the annoyance ratings

Read more

Summary

Introduction

Tonal noise contains a prominent narrowband component. Machinery noise and wind turbine noise often include such tonal components. Noise assessment guidelines for wind turbine noise are regulated in several countries and regions, and a noise “penalty” is added to. Regarding the tonal component in the wind turbine noise, it was reported that some wind turbine noises include tonal components within the frequency range of 50–1000 Hz with a maximum TA level of approximately 15 dB [6]. In view of this fact, the tonal noise problem may be problematic in Japan, and the manual requires the measurement of TA according to the guidelines of foreign countries.

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call