Abstract
A mockup experiment of subcriticality measurement with a digital reactivity meter during criticality approach in a PWR was carried out using plant data. There are some difficulties in the direct application of a digital reactivity meter to the subcriticality measurement. Some treatments were needed in using the count rate of Source Range (SR) detector as input signal to the digital reactivity meter. To overcome these difficulties, we proposed a digital reactivity meter combined with a methodology of the modified Neutron Source Multiplication (NSM) method with the fundamental mode extraction. In this study, the neutron source strength was defined as a constant in terms of a known initial stable subcriticality and the neutron signal from a steady state condition. Even though initial stable subcriticality might be contained some errors, the errors of estimated subcriticalities do not depend on the error contribution of initial stable subcriticality when we normalize the estimated subcriticalities with exactly known reference subcriticality. It was proved that the digital reactivity meter could be used not only for the subcriticality measurement or control rod worth measurement but also for the continuous monitoring of the subcriticality during criticality approach.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.