Abstract

Subcooled flow boiling has been investigated for horizontal mini and micro channels of which hydraulic diameters are 1mm and 150μm, respectively for high heat flux cooling in electronics. The heating surface is 1mm in width and 10mm in length for the mini channel. Eleven micro grooving are made on the copper heating block of 5.25mm×5.25mm. Aqueous solutions of ethanol, 10% and 50% in mass concentration, are used as boiling liquid for the micro channel. Microbubble emission boiling (MEB) of water is generated at liquid subcooling of 40K in the mini channel as same cases of conventional macro channels and the maximum heat flux obtained is a 10MW/m2 at liquid velocity of 1m/s (1000kg/m2s). However, the boiling turns to film boiling at low liquid velocity, 0.3m/s (300kg/m2s) for an example. In subcooled boiling of aqueous solutions, the heat flux becomes small for the lower ethanol concentration. The critical heat fluxes are well agreed with the existing theories and the maximum heat fluxes are higher than CHF. However, no micro bubble emission boiling is observed in subcooled flow boiling of mini channels and the CHF is considerably smaller than the existing theories. It is difficult to generate MEB for micro channels with heating surface of large thermal capacity because the coalescing bubbles formed on the heating surface are filled up in the channel and the liquid vapor exchange is disturbed.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.