Sub-ms laser pulse irradiation on tungsten target damaged by exposure to helium plasma

Abstract

The effects of a transient heat load on tungsten damaged by helium plasma irradiation have been investigated using a ruby laser with long pulse duration in the divertor simulator NAGDIS-II (Takamura et al 2002 Plasma Sources Sci. Technol. 11 A42). The pulse width of the ruby laser was ∼0.6 ms, which is close to that of the expected heat load accompanied by type-I edge localized modes (ELMs) in ITER operation. Helium holes/bubbles, which were formed in the surface region of powder metallurgy tungsten due to the exposure to the helium plasma, disappeared after the laser pulse irradiation to the tungsten surface with sufficient pulse energy. The results indicated that the transient heat loads similar to those expected by ELMs will mitigate damages such as bubbles and holes produced by helium irradiation. When a vacuum plasma sprayed tungsten coating on graphite was exposed to the helium plasma, the surface was covered with arborescent nanostructured tungsten containing many helium bubbles inside the structure. Melting traces were found on the surface after the laser pulses irradiated the surface even though the pulse energy was lower than that for melting bulk tungsten. A numerical temperature calculation of the sample suggested that the effective thermal conductivity near the surface dramatically decreased by several orders of magnitude due to the formation of nanostructured tungsten.