Abstract
The aim of this paper is to analyze the influence of adding serial inductance in AC side of the 3ph -6 pulse bridge rectifier on the reduction of harmonic distortion rate. A simulated model with serial inductance was analyzed. The 3-phase 6-pulse diode bridge rectifier was chosen because it corresponds to the operation of the 6-pulse thyristor bridge rectifier at maximum load (while keeping the angle α = 0). Both the total harmonic distortion (THDi) and the power factor (PF) for the circuit have been measured. The results obtained of the THDi has been recorded for four values of serial inductance and results was compared with the (IEEE 519-1992) standard. Comparison results indicates that for values of inductive reactance (Xi) up to 67% cause a reduction of THDi which is above the standard values, while for (Xi) more than 67% cause a reduction in THDi within the acceptable standard level. Analyzing of results prove that the adding of serial inductance at the AC side leads to good reduction in harmonic distortion rate, but with some reduction in power factor value, which results in some energy losses.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.