Abstract
Stainless steel is widely employed in a variety of industries, including aerospace, chemical processing, and transportation. It can be recycled indefinitely with no loss of property. The Gas Tungsten Arc Welding (GTAW) or Tungsten Inert Gas (TIG) technique is widely used for connecting thin pieces of stainless-steel. However, it is ineffective for combining heavy parts in a single pass. Activated TIG (A-TIG) dramatically enhances weld penetration up to 1.5- 4 times in a single pass. A-TIG is the centre of investigation among researchers because of its deep penetrating capacity. This article discusses the effects of particular flux powders, such as NaF and Fe2O3, on surface appearance and geometric shape. Weld of satisfactory appearance is produced using NaF powder as a flux in TIG welding, whereas, Fe2O3 powder results in a substantial increase in both the joint-penetration and weld-aspect ratio.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
