Abstract
Polycrystalline diamond (PCD) tools have gained increasing application in woodworking industry for the phenomenal tool life and cutting finish compared with carbide tools. In the paper, machining experiments with PCD tools were conducted to mill laminated flooring with Al 2O 3 overlay. Four kinds of PCD products with different original diamond grain sizes were used to fabricate the cutters. Wear volume was measured by optical microscopy and wear morphology was examined by SEM and optical microscopy. The experimental results show that the wear mechanisms of PCD tools, in the machining process, involve inter-granular wear and partial cleavage fracture. The microcracks in PCD tools are a key reason for the wear of tools. By comparing the flank wear, the experiments reveal that PCD tools with middle original diamond grain size have long tool life. The influences of original diamond grain size on cutting edge and wear properties have also been discussed in detail.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Refractory Metals and Hard Materials
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
