Abstract
An experimental investigation was carried out on Hawkesbury sandstone samples to study the peak strength variations during triaxial monotonic and cyclic compressive testing. Axial load, confining pressures and axial and lateral deformations were measured precisely from start of loading until post-peak state. Cyclic tests were carried out at different stress levels and unloading amplitudes. All the tests were performed at 4 MPa confining pressure. A methodology to conduct cyclic loading testing was devised including the development of an innovative peak strength prediction method. The results confirmed that beginning of cyclic loading at higher stress will result in failure after fewer cycles. Moreover, it was found that if the specimen experience more cyclic loading the failure mode will be more brittle. The mechanical properties of the rock were altered by systematic cyclic loading; dependent upon the applied stress level during cyclic loading the rock may become weaker or stronger as a result of cyclic loading. It was identified that a critical maximum normalized deviator stress (i.e. deviator stress at the beginning of unloading normalized by rock peak strength) exists between 93.7 and 94.1 % which defines the limit between peak strength hardening and weakening during cyclic loading. If the cyclic loading deviator stress is lower than this critical boundary, the peak strength increases up to 11 %. This increase in peak strength is directly proportional to the normalized deviator stress in unloading; the amount of increase in peak strength decreases with a decrease in cyclic loading deviator stress.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Geomechanics and Geophysics for Geo-Energy and Geo-Resources
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.