Abstract
Spray cooling is an effective tool to dissipate high heat fluxes from hot surfaces. This article thoroughly investigates the effect of thickness of a hot stainless steel plate on the cooling time, cooling rate, heat flux, and heat transfer coefficient under constant mass flow rate maintained at 1 MPa using water as the coolant. Cylindrical samples of stainless steel with constant diameter (D = 25 mm) and thickness (δ = 7.5, 12, 16.5, and 21 mm) were used in the present study. Critical droplet diameter to achieve an ultra-fast cooling rate of 300°C/s was estimated by using an analytical model for samples of varying thicknesses. The analytical model (one side spray cooling) showed good agreement with experimental results with a relative error of 3.2% in the plate thickness range of 1–12 mm. An increasing trend in maximum heat flux was found with increasing thickness of the plate. Maximum heat flux as high as 1,800 kW/m2 was achieved for a 21-mm-thick sample. Heat transfer coefficients in the range 0.092–96.24 kW/m2K, 0.111–98.9 kW/m2K, 0.074–63.4 kW/m2K, and 0.127–55.63 kW/m2K were reported for sample of varying thicknesses in the present study. Limited published work is available with reference to water spray cooling dynamics and thickness of stainless steel plate. Therefore, the present study focuses on the correlation between the thickness of the plate and spray dynamics of water spray cooling.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
