Abstract

Synergy inhibition of wire mesh and spray mist on syngas explosion was researched. The correspondence between the explosion parameters under success and failure conditions were analyzed, and its influence regular and inhibition mechanism were revealed. An evident difference appeared in the correspondence at different synergy results. Compared with the failure, the pressure of lower end only experienced an acceleration rise under the success condition although the propagation velocity of flame was slightly increased as it approached wire mesh. Corresponding pressure was also reduced. After passing through wire mesh, flame propagation was evidently accelerated due to the turbulence disturbance caused by wire mesh despite the strong endothermic effect of mist. The corresponding explosion reaction rate was also increased. Pressures of two ends did not appear obvious change under the success condition, but the pressure of upper end was evidently reduced compared with the failure. Due to the combined effect of wire mesh disturbance and mist heat absorption, the velocity history showed a change of increasing firstly and then decreasing as the spray time increased after passing through wire mesh. The synergy inhibition was attributed to the combined physical and chemical effects, and was related to the syngas concentration and spray amount.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.