Study on the repair parameters for trailing‐edge bonding failure of wind turbine blade in service

Abstract

AbstractA numerical analysis method of trailing edge deboning is proposed in this paper. Using this method, multiple repair parameters can be quantified by analyzing aerodynamic responses and structural characteristics of the trailing edge. This method can be applied to three types of trailing edge, including blunt trailing edge, transitional trailing edge, and pointed trailing edge. In this study, the repair parameters are divided into two types, including the internal parameters that can affect the bonding strength and the external parameters that can affect the stiffness and aerodynamic shape. The main research steps are as follows: First, a repair structure shell‐body model was developed. Second, static tensile tests were carried out using 49 specimens, covering two lap joint types and seven bonding thicknesses. Finally, nine different repaired trailing edge models were developed using Ansys/Fluent for each two two‐dimensional airfoil. A 30–40 m section of a 71 m blade was used to develop a three‐dimensional (3D) rotating model with the repaired trailing edge. The simulation results show that the two internal parameters, overlap length and the slope of adhesive joints, are the key to improving the bonding performance of the pointed trailing edge. In addition, the bonding thickness range of 1–10 mm is proved by the experiment results and numerical analysis to be sufficient for good bonding performance. Besides this, the influence of the repair height on the aerodynamic pressure distribution and lift coefficient is much greater than the repair width, and the torque and power of the repaired 3D blade model are 1.91% higher than that of the original blade. This should further help provide an effective theoretical basis for determining the repair plan for a wind turbine blade.