Abstract
FeCrNi/CBN cored wire is prepared by use of the pull-type flux cored wire machine (FCWM50 type), FeCrNi/CBN composite coating is made by high velocity arc spraying. The special properties of the composite coating can be improved by adding Cr, Ni and small amounts of rare earth elements to adjust the coating composition. The Tribological properties of FeCrNi/CBN composite coating with high velocity arc spraying is studied. Images and components and cross-section microstructure of coatings are analyzed by means of SEM, and EDS, etc. This research indicated that FeCrNi/CBN composite coatings have typical layered structure feature and high bond strength and hardness. Friction of coatings at near room temperature or higher has “Run-up” period. With the increase of temperature, friction coefficient of coatings becomes low and wearing capacity of coatings high. The adding of CBN powder highly improved the wearing capacity of coatings.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
