Abstract
The FE model of the pretightening assembly moving beam of open-die forging hydraulic press is built with FE simulation software ABAQUS in the study. With the FE model, the force status of pretightening assembly moving beam is studied. Then the pretightening force of assembly moving beam is further studied and the computing method of pretightening force is given. The main achievements of the study include: Under pretightening, the stress of main moving beam is very low and that of guild sleeves is also lower than the allowable stress. Under center loading, the stress of the center field of main moving beam is higher and that of guild sleeves is almost same to that of pretightening. Under eccentric loading, the stress of same deviation field of main moving beam is higher and the effect of pretightening force on the stress of main moving beam is very small. The stress distribution of guild sleeves with different pretightening force is same and the effect of pretightening force on its strength is very low. The pretightening force of tension rod can be computed with the force of press, the allowable eccentric value of the workpiece, the distance between up guild section and down guild section of guild sleeve and the quantity of tension rods. The results of the study are very useful to design and install the pretightening assembly moving beam of open-die forging hydraulic press.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
