Abstract
Paste backfill mining is an significant part of green coal mining, which can improve resource utilization and extend the service life of mines. It is important for solving the “three under, one above” mining problem and avoiding industrial wastes such as coal gangue and fly ash that occupy farmland and pollute the environment. To address the difficult filling problem of a fully mechanized top-coal caving face (FMT-CCF), a new method of partial paste backfill mining is herein proposed. First, the partial paste backfill mining method and implementation steps of the FMT-CCF are introduced in detail. Then, the mechanistic model of the roof beam in partial paste backfill mining is established. Then, the filling structural factors on the filling effect of the 42105 FMT-CCF are determined. Dependent on the assay of the migration law of overlying stratum after filling, numerical simulation analysis is used to research the feature effect of the main filling structural factors on the filling effect. Finally, the paste filling rate, filling width, and filling strength suitable for the 42105 FMT-CCF are obtained. When the filling rate reaches 100%, a significant alteration takes place, resulting in the efficient decrease of the overlying rock stress arch shell’s height. As the width of the filling body expands from 10 m at each end to 20 m, the stress arch of the overlying rock experiences maximum reduction, specifically decreasing by approximately 14 m. When the strength of the filling body is greater than 0.4 GPa, the filling effect is better. This study has important guidance and reference significance for the partial paste backfill of FMT-CCF in thick seam mining.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have