Abstract
Sustainable development in coal mining requires a continuous and efficient method of coal extraction. Research shows that gob-side entries retained through roof cutting retained gob-side (RCGE) are vital for improving mining efficiency, enhancing coal recovery rates, and enabling continuous production. However, the mechanism of surrounding rock deformation during close-distance co-mining of coal seams with this technique is not yet clear. For the Jiaokou coal mine in China, due to an unreasonable stagger distance between upper and lower working faces, the gob-side entries retained at the 9102 tailgate and 10102 headgate experience severe rock pressure, leading to significant prop damage and a sharp reduction in the cross-section of the entry. This greatly hampers the reuse of these entries. To investigate this issue, we established a model to study the stress distribution of surrounding rocks at different stagger distances (20 m, 40 m, 60 m, 80 m, and 120 m) through numerical simulation and optimized the support parameters for the retained entries. Our research found that when the subsidence of the roof in the upper coal seam exceeds 0.74 m but is less than 1.33 m, there is sliding instability in the mining body. When the subsidence exceeds 1.33 m, the mining body will rotate and deform, causing significant mining pressure within the retained entry. A stagger distance of 40 m between the upper and lower working faces can reduce pressure on the face during the mining of the lower coal seam. Extensive field measurements of rock pressure revealed that the damage rate of the single column in the gob-side entries of the upper and lower coal seams does not exceed 5% and 1%, respectively. In summary, this study provides a practical method to reduce damage to entries during the mining process, thereby increasing the continuous production capability of the coal mine. This is critical for the sustainable development of coal mining.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have