Abstract
This paper is about the lubricating wear-resisting coating KF301/WS2 and round pit texturing modified coating KF301/WS2 which are prepared by supersonic plasma spraying, laser remelting and surface texturing technology, tribological characteristics of two kinds of coatings are studied under room temperature, according to this, it is discussed for lubrication antifriction mechanism. The research shows: round pit texture has a certain influence on friction factor of coating’s surface and abrasion loss. Friction coefficient of untextured surface is about 0.0138 in the initial stages, while friction coefficient of round pit texture is about 0.01, compared with the former, the latter decreases 27%; when wear time reaches to 1 hour, abrasion loss of untextured surface is 0.0026mg, while abrasion loss of round pit texture is about 0.013mg, compared with the former, the latter decreases 50%. The lubricant antifriction performance of round pit texture is higher than untextured surface, this is because friction coefficient of coating is decreased as the change of the third-body bed, and round pit micro moulding can collect abrasive particle, decreasing the influence of abrasive particle.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.