Abstract
This paper designed a micro planar induction heater for thermal bubbles generation. The micro heater which consists of a micro planar coil, a copper heating plate and a glass slide was fabricated with MEMS fabrication process. The relations between the heating performance and the thickness of heating plate were studied in the simulation with the software of COMSOL. The experimental system has been built and the experimental tests for thermal bubble generation have been also carried out with the prototype. The process of thermal bubbles generation was recorded by the video camera. The frequency of AC current applied in the experiment is 100 kHz and the heating time of 1 s. The experimental results indicated that the micro heater has the best heating performance with the heating plate thickness of 12---16 μm, and the minimum power for thermal bubbles generation was only 0.427 W. This micro heater can be applied to a variety of thermal bubble devices, such as micro actuator, micro ejector and micro pump.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
