Study on the effect of dimethyl ether and diesel-castor biodiesel blends on emission and combustion characteristics

Abstract

The biodiesel from Castor was, investigated with a water-cooled four-stroke diesel engine of model CT 110 with B0, B5, and B10 without and with dimethyl ether (DME) of 2 % and with a fixed load of (80 %) to study the combustion and emission. The biodiesel was made by alkaline transesterification with NaOH as a catalyst. Using established test protocols, the fuels' characteristics, including their viscosity, surface tension, heating value, flash point, and elemental makeup, were measured. Experimental research is used to determine how the pressure and heat release rate affect the performance characteristics of both reference fuel and the blends. The combustion studies are conducted with engine speeds of 1800, 2400, and 3000 rpm and emissions were analyzed with engine speeds starting from 1600 rpm to 3000 rpm with exhaust gas analyzer Gunt, CT159.02 digital analyzer. From the combustion analysis when the blend ratio increases the cylinder pressure (CP) and heat release rate (HRR) also increase due to oxygen molecules in the biodiesel. The addition of DME to biodiesel blends reduces carbon monoxide (CO) emissions relative to neat diesel and biodiesel blends. With the increase of diesel castor biodiesel blends, nitrogen oxide (NOX) emissions decreased as a result of the reduction in the HRR. The effect of castor diesel biodiesel blend on the NOX emissions shows, that when the blend ratio increased the NOX emissions also increased. When DME is added to a higher blend ratio of castor biodiesel, the engine is operated only at higher engine speed. Specifically, for B10 NOX emission was detected after engine speed of 2500 rpm. When the engine ran with DME for blends of castor biodiesel the engine was not operated at low engine speed. The increase of diesel castor biodiesel blends in the case of DME mixture unburned hydrocarbon (UHC) emissions increased. The finding of this research work was as the biodiesel blend increased the cylinder pressure and heat release rate also increased. So, using sustainable biodiesel-diesel blends made from castor oil with DME additive it is advisable to operate diesel engines for better emission regulation.