Abstract
Inconel 718 is widely used in aerospace, nuclear power and gas turbine industries. On the other side, it is well known as one of the most difficult-to-cut super alloy and its efficient machining assumes a lot of importance. Therefore, this paper presents an experimental investigation on the cutting force of Inconel 718 machined with several different kinds of cutting tools. Both single-factor and orthogonal experiments were carried out with cemented carbide, cermet and CBN tools. The effects of cutting tools and cutting parameters on the cutting force are investigated and the optimal cutting conditions are recommended.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
