Abstract
In fusion welding, gravity makes a molten metal flow downward and it sometimes causes an irregular shaped weld bead and weld defects such as an undercut. To solve this problem, the authors propose a new electromagnetic controlled molten pool welding process method which controls the molten metal flow by using upward electromagnetic forces, and the applicability of this method to industry is examined. In flat position welding with excessive heat input, the molten metal tends to sag down and an undercut defect is likely to occur. It is found that the upward electromagnetic force given by adjusting the conditions of magnetic field can lift the molten metal up, resulting in the remarkably improved shape of a penetration bead. It is further found that, even in overhead position welding, a well shaped penetration bead without undercuts is obtained by adjusting the welding touch angle as well as magnetic field conditions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.