Abstract
In order to study the surface asperity flattening in a quasi-static cold uniaxial planar compression, the experimental results of atomic force microscope and electron backscattered diffraction have been employed in a rate-dependent crystal plasticity model to analyze this process. The simulation results show a good agreement with the experimental results: in this quasi-static deformation process, lubrication can hinder the surface asperity flattening process even under very low deformation rate. However, due to the limitation of the model and some parameters, the simulation results cannot predict all the properties in detail such as S orientation {123} , and the maximum stress in sample compressed without lubrication. In addition, the experimental results show, with an increase in gauged reduction, the development of Taylor factor, and CSL boundaries show certain tendencies. Under the same gauged reduction, friction can increase the Taylor factor and Σ = 7.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.