Study on stress variation of advance fiberglass anchor bolts during tunnel excavation process

Abstract

One of the main causes for excessive deformation within a tunnel is due to the instability of the soil or soft rock ahead of the excavation face. Fiberglass bolts have been shown to be a useful advance reinforcement method for the excavation face. In this paper, an improved ADECO-RS (Analysis of controlled deformation in rock and soils) method had been proposed for soft rock mountain tunnels, in terms of the partial (mainly the upper bench) excavation face reinforcement and also for the bench excavation method. Strain gauges were used to test the micro-strain in the fiberglass bolt to investigate how the axial force of the fiberglass bolt varied during the tunnel excavation. In addition, combined with the field tunnel deformation monitoring data, the relationship between the reinforcement parameters of the fiberglass bolts and the tunnel construction phase were discussed. The research results show that: (1) The stress state of the anchor rod is related to the reinforcement length of the anchor rod; (2) Excavation within the lap area of the fiberglass bolt leads to an increase in the axial force of the bolt, while excavation outside the lap area of the fiberglass bolt has no effect on the anchor; (3) Reducing the reinforcement area of rock mass will affect the stability of the excavation. To ensure the stability of the excavation face, the initial support construction loop should be completed as soon as possible; (4) In a future project with similar conditions, the recommended lap length of the fiberglass bolt could be 3 m utilizing the fiberglass bolt grouting face reinforcement method.