Abstract
The study investigates the ability to remove copper, tin and arsenic from iron ore, scrap and liquid steel based on the literature and thermodynamic calculations using the FactSage 7.2 software. Methods of removing Cu, Sn and As from iron-bearing materials, feasible in industrial conditions in the near term, were selected. Simulation tests with the use of the FactSage 7.2 software showed that under reduced pressure conditions Cu and Sn can be removed from the steel bath, while As evaporation is not possible. Laboratory tests were carried out, including the removal of Sn and Cu in the process of degassing of liquid steel in a deep vacuum in a vacuum induction furnace and the removal of Sn from iron ore in the sintering process. Under conditions of deep vacuum (below 40 Pa), high temperature (1670°C) and a correspondingly long vacuum treatment time (over 30 minutes), the efficiency of removing the copper and tin contents from the liquid steel of approximately 14 and 17% respectively was obtained. The iron ore sintering test with a high Sn content showed the effectiveness of reducing the Sn content during this process, amounting to approx. 30%.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
