Abstract
The authors are doing research to develop a rapid curing device by using inductive heating for the production of a laminated rubber bearing. In the previous paper, it was shown that three problems exist; i.e. (i) the slit mold necessary, (ii) lower uniform temperature in the radial direction, and (iii) necessary temperature control by the internal location temperature, when the commericial frequency (60 Hz) induction heating was used to vulcanize a laminated rubber. This paper demonstrates that ultra low frequency heating is adequate to cope with the above problems. It will be shown that (i) the mold is not necessary a slit, (ii) the radial temperature difference is within ±5°C, and (iii) the internal temperature can be controlled by the side mold temperature, as the result of ultra low frequency induction heating test.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.