Abstract
Due to the low efficiency of magnetic abrasive finishing and the difficulty in the making of magnetic abrasive grain, this article compares three different ways of its making, i.e. hot pressed sintering, spark plasma sintering (SPS) and ab-adhesive bonding sintering. SPS is found to have a higher cost, but it makes up the deficiency in magnetic abrasive grain made either by hot pressed sintering or by felt, with high abrasion resistance, processing efficiency and better processing performance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
