Abstract
Water-soluble polyaniline (PANI), prepared by chemical-oxide and SmBaCuMO5+δ (M=Fe, Co, Ni)(SBCM) powders, prepared by sol-gel method were analyzed through Fourier transform infrared spectroscopy (FT-IR) spectra, X-ray diffraction (XRD), transmission electron microscopy (TEM) and energy dispersive spectroscopy (EDS) respectively, so as to investigate the gas sensitivities of PANI/SmBaCuFeO5+δ (SBCF) and its sensitivity to NH3 under room temperature. The results showed that all of SBCM powders were of double-perovskite structure and PANI was successfully obtained. Under the same condition, the gas sensor based on PANI/SmBaCuFeO5+δ (SBCF) material exhibited higher resistance sensitivity, better selectivity and shorter response-recovery time than others. The resistance sensitivities to NH3 increased with the increasing of atom radius of M in PANI/SBCM.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.