Abstract
In concentrically rotating double cylinders consisting of a stationary outer cylinder a rotating inner cylinder, Taylor vortex flow appears. Taylor vortex flow occurs in journal bearings, various fluid machineries, containers for chemical reaction, and other rotating components. Therefore, the analysis of the flow structure of Taylor vortex flow is highly effective for its control. The main parameters that determine the modes of Taylor vortex flow of a finite length are the aspect ratio, Reynolds number Re. Aspect ratio is defined as the ratio of the cylinder length to the gap length between cylinders, and Re is determined on the basis of the angular speed of the inner cylinder. Aspect ratio was set to be 4.0, and Re to be values in the range from 100 to 1000 at intervals of 100. Thus far, a large number of studies on Taylor vortex flow have been carried out; however, the effects of the differences in initial conditions have not yet been sufficiently clarified. In this study, we changed the acceleration time of the inner cylinder in a numerical analysis, and examined the resulting changes in the mode formation and bifurcation processes. The acceleration time was changed from 1.0 s to 10.0 s. As a result, a difference was observed in the final mode depending on the difference in the acceleration time. From this finding, non-uniqueness, which is a major characteristic of Taylor vortex flow, was confirmed. However, no regularities regarding the difference in mode formation were found and the tendency of the mode formation process was not specified. Moreover, the processes of developing the vortex resulting in different final modes were monitored over time by visual observation. Similar flow behaviors were initially observed after the start of the calculation. Then, a bifurcation point, at which the flow changed to a mode depending on the acceleration time observed, and finally the flow became steady. In addition, there was also a difference in the time taken for the well-developed flow to reach the steady state. Both EFD (Experimental Fluid Dynamics) and CFD (Computational Fluid Dynamics) results show good agreement qualitatively.
Highlights
In concentrically rotating double cylinders consisting of a stationary outer cylinder a rotating inner cylinder, Taylor vortex flow appears
Taylor vortex flow occurs in journal bearings, various fluid machineries, containers for chemical reaction, and other rotating components
The main parameters that determine the modes of Taylor vortex flow of a finite length are the aspect ratio, Reynolds number Re
Summary
I. Taylor in 1923 [1], the Taylor vortex has been widely investigated and even limited to major studies, more than 1500 research papers have been published so far. The Taylor vortex is regarded as one of the most important vortexes in “flow”. Let us briefly explain the Taylor vortex. Thereby, if the centrifugal force working on the fluid and surrounding pressure are imbalanced, the vortex rotating alternatively in the opposite direction having an axis in the direction of flow is formed.
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
