Abstract

Series of orthogonal cutting tests of aluminum alloys have been carried out to investigate the chip formation process and adhesion of the work material to the rake face of the cutting tool under near dry cutting conditions. Almost no adhesion of the work material was observed over a wide range of cutting speed tested when the aluminum alloy was cut with the sintered diamond cutting tool. On the other hand, large amount of adhesion of the work material was observed at low cutting speeds, when cut with the carbide and DLC-coated tools. The amount of the adhered material is reduced with an increase in the cutting speed. The average coefficient of friction on the rake face increases almost in linear relation with the amount of adhesion. The chemical components of the adhered layer were also analyzed by EDS and AES techniques.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.