Study on Kinematic Structure Performance and Machining Characteristics of 3-Axis Machining Center

Abstract

The rigidity and natural frequency of machine tools considerably influence cutting and generate great forces when the tool is in contact with the workpiece. The poor static rigidity of these Vertical Machining Centre machines can cause deformations and destroy the workpiece. If the natural frequency of the machines is low or close to the commonly used cutting frequency, they vibrate considerably, resulting in poor workpiece surfaces and thus shortening the lifespan of the tool. The main objective of this study was to develop an experimental technique for measuring the effect of machine tool stiffness. The static rigidity of the X-axis was found to be 2.20 kg/μm, while the first-, second-, and third-order natural frequencies were 27.3, 34.4, and 48.3 Hz, respectively. When an external force of 1000 N was applied, the Y-axis motor load was found to be approximately 2740 N-mm. In this study, the finite element method was mainly used to analyze the structure, static force, modal, frequency spectrum, and transient state of machine tools. The results of the static analysis were verified and compared to the experimental results. The analysis model and conditions were modified to ensure that the analysis results were consistent with the experimental results. Multi-body dynamics analyses were conducted by examining the force of each component and casting of the machine tools and the load of the motor during the cutting stroke. Moreover, an external force was applied to simulate the load condition of the motor when the machine tool is cutting to confirm the feed. In this study, we used topology optimization for effective structural optimization designs. The optimal conditions for topology optimization included lightweight structures, which resulted in reduced structural deformation and increased natural frequency.