Abstract
The parts with axial special-hole, which are difficult to be processed by traditional machining process because of the high cost and low efficiency, are widely used in many fields. In this paper, a new practicable method to form axial special-hole by open-die cold extrusion is put forward. The four failure types of forming axial irregular-holes by open-die extrusion are analyzed. The key parameters, cone angle, reduction, original ratio of the thickness-diameter, etc., which largely influence forming process and the limits range is analyzed by numerical simulation , and make an experiment to verify the results. Based on the analysis, the law of shaping and the limit of the key parameters are concluded. The optimum range of the die’s cone angles is from 16° to 22°.The largest reduction is 24% for the billets with concave outer profile and 22% for the billets with convex outer profile.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
