Abstract
The paper deals with wet chemical anisotropic etching of Si(hkl) wafers in KOH solutions containing isopropyl alcohol. The impact of KOH and alcohol concentrations on the etch rates of (hkl) planes is shown. The effect of KOH concentration in pure KOH solutions resembles the one in KOH solutions non-saturated with alcohol and is different from the one in KOH solutions saturated with isopropanol. The increase in alcohol concentration in the etching solution generally reduces the etch rates of the selected (hkl) planes. However, when the alcohol concentration reaches the saturation level, the (100) and (311) etch rates increase. This is difficult to explain since the increased alcohol concentration should cause enhanced adsorption of the alcohol molecules on Si surface, as it is suggested by surface tension measurements. Thus, the denser adsorption layer should lead to the etch rate reduction. The influence of isopropanol concentration on the morphology of the (hkl) surfaces is also studied. The increase in the alcohol concentration leads to disappearance of hillocks on (100) and (h11) surfaces.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
