Study on damage characteristics and application of gypsum pillar strengthened with FRP

Abstract

The instability of mine pillars has posed a serious threat to the safety of mines in China. In order to reduce the risk of pillar instability, this study used fiber-reinforced polymer (FRP) to reinforce gypsum specimens and conduct mechanical loading experiments. The study investigates the reinforcement effect of gypsum specimens with different height-diameter ratios and different FRP wrapping thicknesses, and analyzed the uneven distribution of constraint force along the height direction of FRP-reinforced gypsum specimens. An optimized wrapping method was proposed, and a stress–strain constitutive model for gypsum materials under optimized wrapping was established. By utilizing a statistical method based on strain energy density for heterogeneous rock damage identification, a simulation study was conducted on FRP-reinforced gypsum-like specimens. A comparative analysis was carried out with experimental results to verify the feasibility of the constitutive model. The research findings indicate that the use of FRP reinforcement significantly improves the uniaxial compressive strength and strain values of gypsum-like specimens. Moreover, the smaller the aspect ratio, the more pronounced the effect of FRP reinforcement on gypsum-like specimens. The stress–strain curve of FRP-reinforced gypsum-like specimens shows a distinct combination of curves and straight lines, which can be divided into two distinct stages based on different elastic moduli. The peak value of acoustic emission energy of FRP-reinforced gypsum specimens appears at the junction of the first and second stages of the stress–strain curve, and then the acoustic emission energy curve becomes relatively flat, with an increase in peak energy before failure. The constraint force acting on FRP-reinforced gypsum specimens exhibits an obvious uneven distribution along the height direction, based on which an optimized reinforcement scheme is proposed. Based on the established constitutive model, numerical simulation was conducted using real data from a specific mine. The research findings demonstrate that when the optimized reinforcement method is employed, the load-bearing capacity of the mine pillars was significantly enhanced. The maximum displacement was reduced by 33%, the maximum vertical stress was reduced by 3.2%, and the volume of the plastic zone was reduced by 39.87%.