Study on Boiling Heat Transfer Characteristics of Composite Porous Structure Fabricated by Selective Laser Melting.

Abstract

Surface porosity is an important means of enhancing boiling heat transfer. In this paper, two kinds of composite porous structures of surface micropore + square channel and framework micropore + square channel were prepared by selective laser melting technology using AlSi10Mg as the powder material. The effect of composites with different pore forms on boiling heat transfer was investigated in pool boiling experiments. It was found that controlling the thickness of the powder layer manufactured by selective laser melting can change the surface roughness of the sample, and the sandblasting treatment reduced the surface roughness of the samples. The average heat transfer coefficient of the rough surface composite porous structure sample was increased by 40% compared to the sandblasted sample. The micropores on the surface of the sample and inside the framework significantly enhanced the heat transfer coefficient of the composite porous structure. The presence of surface micropores increased the heat transfer area and the vaporization core density of the composite porous structure and exhibited excellent heat transfer coefficient improvement in the low heat flux region. The framework microporous composite porous structure can form effective gas-liquid diversion at high heat flux and obtain higher heat transfer performance. The large channel in the composite porous structure is the key control factor of the critical heat flux.