Abstract
It’s very difficult to get high precision measuring result using contact torquemeter because of very low signal-to-noise ratio. To overcome this defect, a wireless torque measuring system is designed based on CC2500. This system uses strain gauge torque sensor to measure the surface principal stress of the transmission shaft, and get the maximum shearing stress, and then the torque that the transmission shaft bears. The weak output signal of torque sensor is magnified by the instrumentation amplifier AD623, and sent to the analog-to-digital convertor. These digital data are transmited to the portable receiving terminal by the wireless transceiver chip CC2500. The dynamic wireless torque measurement is realized by this system.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.