Abstract
Objective. Currently, engineering waterproofing systems with polymer waterproofing membranes are widely used at various construction structures. At the same time, the usage of polymer membranes implies the operation of break welds, the strength of which should be no less than the strength of the waterproofing material itself. The purpose of the study is to evaluate the water resistance of single seams (without test channels, welded by manual or automatic equipment) for LOGICBASE™ / ECOBASE™ grade V-SL polymer membranes at a pressure of 1 MPa. Method. Testing of waterproofing seams for water resistance is carried out according to the requirements of GOST EN 1928-2011, method B. The GESTER model GT-C26B hydrostatic pressure testing device is used as a test installation. LEISTER welding equipment of Varimat V2 (automatic equipment) and Triac AT (manual/hand equipment) models was used for welding samples. The width of the weld was at least 30 mm. Result. At a hydrostatic head pressure of 1 MPa, within 24 hours from the start of the test, there were no traces of water penetration in the samples, which indicates that the seams are completely waterproof. Conclusion. Single seams of LOGICBASE™/ECOBASE™ engineered waterproofing PVC membranes are completely sealed at 1 MPa water pressure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Herald of Dagestan State Technical University. Technical Sciences
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.