Study of the properties of compatibilized ABS/PA6 blends using response surface methodology

Abstract

AbstractStyrene‐(maleic anhydride) copolymer (SMA) compatibilized blends of acrylonitrile‐butadiene rubber (ABS) and polyamide 6 (PA6) with a variety of compositions and compatibilizer levels were prepared at various screw speeds in a corotating twin screw extruder. A Box–Behnken model for three variables, with three levels, was chosen as an experimental design, and the mechanical properties of the blends were considered as the responses. Each response was analyzed and formulated versus the considered factors by the use of response surface methodology. Impact resistance increased with increased SMA concentration and reduced screw speed. In compatibilized samples, with an increase in PA6 content, higher impact resistance was observed. Increasing PA6 content and SMA concentration, as well as decreasing screw speed, gave improvements in both tensile and flexural strengths. In each case, all of the correlations among factors were studied. Grafting of SMA was proved by detecting the graft copolymer (SMA‐PA6) formed through extraction in formic acid and FTIR spectroscopy. Compared with uncompatibilized blends, compatibilized samples displayed more uniform and finer particle sizes, thereby proving the compatibilizing effect of the graft copolymer. The asymmetry trend in dispersed particle size before and after the phase inversion became more differentiated in the presence of the compatibilizer. Adding SMA lowered the phase inversion composition (based on PA6), whereas higher screw speed increased it. J. VINYL ADDIT. TECHNOL., 2009. © 2009 Society of Plastics Engineers