Study of the partial wetting morphology in polylactide/poly[(butylene adipate)‐co‐terephthalate]/polyamide ternary blends: case of composite droplets

Abstract

AbstractThe prediction of the morphology of ternary polymer blends requires a good knowledge of the values of the three interfacial tensions. We selected three polymers, either biobased or biodegradable, polyamide (PA), poly[(butylene adipate)‐co‐terephthalate] (PBAT) and polylactide (PLA), and we accurately measured their interfacial tensions using the retraction method, varying the molar mass or inverting the phases. The following values of interfacial tension were obtained: γPBAT/PLA = 3.3 ± 0.7 mN m−1, γPA/PLA = 5.6 ± 0.3 mN m−1 and γPBAT/PA = 3.0 ± 0.4 mN m−1. These values were used to calculate the spreading coefficients giving rise to two negative coefficients and one coefficient close to zero. Ternary blends with various compositions, two different levels of viscosity for PBAT and different processing conditions were prepared. There was a very good agreement between the predictions of the spreading theory, when using the values of interfacial tension of the right order of magnitude, and the observed morphologies, whatever the polymer serving as a matrix. When PLA or PBAT was chosen as the matrix, the ternary blend morphology was composed of composite droplets, presenting a partial wetting morphology, dispersed in the polymer matrix. This morphology was observed whatever the composition, the viscosity of the PBAT phase and the processing conditions. A further calculation of the free energy confirmed this morphology. The formation process of this semi‐encapsulated morphology was observed during blending. © 2018 Society of Chemical Industry