Study of the mechanical properties of tetrahedral amorphous carbon films by nanoindentation and nanowear measurements

Abstract

Abstract Nanoindentation and nanowear measurements, along with the associated analysis suitable for the mechanical characterization of tetrahedral amorphous carbon (ta-C) films are discussed in this paper. Films of approximately 100-nm thick were deposited on silicon substrates at room temperature in a filtered cathodic vacuum arc evaporation system with an improved S-bend filter that yields films with high values of mass density (3.2 g/cm3) and sp3 content (84–88%) when operating in a broad bias voltage range (−20 V to −350 V). Nanoindentation measurements were carried out on the films with a Berkovich diamond indenter applying loads in the 100 μN–2 mN range, leading to maximum penetration depths between 10 and 60 nm. In this measurement range, the ta-C thin-films present a basically elastic behavior with high hardness (45 GPa) and high Young's modulus (340 GPa) values. Due to the low thickness of the films and the shallow penetration depths involved in the measurement, the substrate influence must be taken into account and the area function of the indenter should be accurately calibrated for determination of both hardness and Young's modulus. Moreover, nanowear measurements were performed on the films with a sharp diamond tip using multiple scans over an area of 3 μm2, producing a progressive wear crater with well-defined depth which shows an increasing linear dependence with the number of scans. The wear resistance at nanometric scale is found to be a function of the film hardness.