Study of the Interface Layer Between Lithium Metal and a Single Ion Conductor Ceramic, Based on Block Copolymer, for Lithium Air Batteries

Abstract

The electrification of transport is a formidable challenge, however the energy storage possible in Li ion batteries is not sufficient to this purpose. A potential option is Lithium-air battery, first because of their very high energy densities and second because of their low costs. Two different approaches to the development of these batteries are possible: the anhydrous system which uses an organic electrolyte, and the aqueous system which uses an aqueous electrolyte [1]. An advantage of the aqueous system is its safety since toxic or inflammable solvents are not used. In order to protect the negative lithium electrode from the aqueous electrolyte, a thin ceramic water and gas tight membrane is used. The interface between the lithium metal and the ceramic membrane plays an important role in the cycling performance of the aqueous lithium air cell. Nonetheless, the poor or non-chemical stability of most ceramic electrolytes in contact with lithium metal limits the performance. A possible strategy to improve the interface between ceramic electrolyte and lithium metal might be by the use of polymer membranes [2]. This study reports the effect of a polymer membrane between a ceramic electrolyte and lithium metal. Block copolymer electrolytes, such as polystyrene-block-poly (ethylene oxide) copolymer electrolyte (SEO) mixed with lithium bis(trifluoromethanesulfonyl) imide (LiTFSI) salt, were used. The single ion conductor ceramic electrolyte was a Lithium Ion Conducting Glass Ceramic (LICGC) purchased from Ohara Corporation (1 inch X 1 inch 150µm thick). Impedance spectroscopy has been used, so as to study the lithium ion - lithium metal transfer from a lithium ion conducting polymer interface. Furthermore, in order to know if the sandwich polymer-ceramic cell showed an additional interfacial resistance, ionic conductivity experiments using electrochemical impedance spectroscopy were performed. Besides, polarization loss quantification at a lithium ion conducting polymer/single ion conductor interface was studied by DC current measurement by the Srinivasan et al method [3]. Finally, in order to confirm the intimacy of the ceramic and the polymer, the interface between the ceramic and the polymer was studied by synchrotron hard X-Ray micro tomography experiments on symmetric lithium-sandwich polymer-ceramic cells. P.G. Bruce, S. A. Freunberger, L. J. Hardwick, J-M. Tarascon, Nature Materials, 11, 19-29 (2012)G.M. Stone, S.A. Mullin, A.A. Teran, D.T. Hallinan, A.M. Minor, A. Hexemer, N.P. Balsara, Journal of the Electrochemical Society 159(3) A222-A227 (2012)Mehrotra, P. N. Ross, V. Srinivasan, Journal of the Electrochemical Society, 161 (10) A1681-A1690 (2014)