Abstract
It is known that the elastic characteristics of polyamides change with increasing temperature; in particular, the Young’s modulus decreases significantly. This fact is practically not taken into account in design calculations of metal-polymer plain (MP) bearings, operating under conditions of the boundary and dry friction. The purpose of the study was the analysis of the effect of temperature on the change of the Young’s modulus and, accordingly, the contact strength and triboresource according to the developed method of calculating MP bearings. MP bearings with a bushing made of polyamide PA6 reinforced with glass or carbon-dispersed fibers were investigated. Quantitative and qualitative regularities of change of the maximum contact pressures and resource of the bearings at temperature increase under conditions of boundary and dry friction are established. The pressures in the bearing bushing made of PA6 + 30GF will be lower than for the bushing made of PA6 + 30CF. The resource of the bushing made of PA6 + 30CF will be significantly greater than for PA6 + 30GF. For thermoplastic polymers, the increase in temperature will have a useful practical effect due to the decrease in the rigidity of the polymer composites of the bearing bushing.
Highlights
Metal-polymer (MP) plain bearings, which have been known since the 1930s, are quite common in modern conditions due to their characteristic positive qualities
Various types of thermoplastic polymers and composites based on them are used as the material of MP bearing bushings, in particular, polyamides PA6, PA46, and PA66
The influence of temperature on the contact pressures and the resource of MP bearings is based on changes in the elastic characteristics of polymer materials
Summary
Metal-polymer (MP) plain bearings, which have been known since the 1930s, are quite common in modern conditions due to their characteristic positive qualities These include sufficiently large load capacity, the possibility of use in dry friction and in a variety of special technological and operational conditions and under shock loads, small axial dimensions in comparison with their diameter, low noise level, damping ability, etc. Despite the rather large area of distribution and scope of MP bearing, the question of the impact of changes in these elastic characteristics of polymer composites, in particular polyamide, under the influence of temperature on their life and the bearing capacity remains poorly understood It is known [1] that the temperature significantly affects the decrease in the
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
