Abstract
Electroforced sedimentation (EFS) is a well-known technique for enhancing the solid content of the final sludge cake. However, the parameters affecting the performance of EFS and quality of the resulting sludge cake, as well as the removed water, are not sufficiently studied. In this research, a mixture of zinc oxide (representing sludge) and polyacrylamide (dewatering aid) were used as experimental materials. The process parameters of electroforced sedimentation were optimized using a design of experiment software (Design Expert ® Version 7.0.0) with a face-centered central composite design (FCCCD) under response surface methodology. An optimization study was carried out for the output response (sedimentation velocity) based on three process factors and an empirical model was developed. The optimized values for current density, total solid volume per unit cross-sectional area and polyacrylamide dose for the highest sedimentation velocity (0.0199 cm/min) were 6.0 A/m2, 7.74 mm and 1.53 % (based on the weight of zinc oxide), respectively. The overall model was significant with Prob > F value of 0.0117 and R 2 value of 0.8911 while the most significant parameter was observed to be the current density with a Prob > F value of 0.0004. Validation experiments were conducted to confirm and measure the accuracy of the models for the three set of parameters including optimum parameters. The error was within the limit of prediction accuracy, and the sedimentation velocity was enhanced by the addition of 1.53 % PAM as dewatering aid. Thus, it was concluded that EFS can be applied successfully for materials having permanent charge.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.