Study of the adsorption of sodium dodecyl sulfate (SDS) at the air/water interface: targeting the sulfate headgroup using vibrational sum frequency spectroscopy

Abstract

The surface sensitive technique vibrational sum frequency spectroscopy (VSFS), has been used to study the adsorption behaviour of SDS to the liquid/vapour interface of aqueous solutions, specifically targeting the sulfate headgroup stretches. In the spectral region extending from 980 to 1850 cm(-1), only the vibrations due to the SO(3) group were detectable. The fitted amplitudes for the symmetric SO(3) stretch observed at 1070 cm(-1) for the polarization combinations ssp and ppp, were seen to follow the adsorption isotherm calculated from surface tension measurements. The orientation of the sulfate headgroup in the concentration range spanning from 1.0 mM to above the critical micellar concentration (c.m.c.) was observed to remain constant within experimental error, with the pseudo-C(3) axis close to the surface normal. Furthermore, the effect of increasing amounts of sodium chloride at SDS concentrations above c.m.c. was also studied, showing an increase of approximately 12% in the fitted amplitude for the symmetric SO(3) stretch when increasing the ionic strength from 0 to 300 mM NaCl. Interestingly, the orientation of the SDS headgroup was also observed to remain constant within this concentration range and identical to the case without NaCl.