Abstract
Manganite perovskite La1-xCaxMnO3 (x=0.33, 0.5 and 0.9) have been prepared by chemical co-precipitation method. Ammonium carbonate was used to coprecipitate lanthanum, calcium and manganese ions as carbonates under basic condition. This precursor on calcining at 900°C yields La-Ca-Mn-O perovskite phase. Follow by sintering at 1200°C after the powders were pressed into pellets gave La1-xCaxMnO3 (LCMO) polycrystalline ceramics. The crystal phases of the resulting powders and ceramics were examined by X-ray diffraction (XRD) technique. The morphology of the powders was observed by scanning electron microscopy (SEM) and electrical transport properties of ceramics were measured by conventional four-point probe technique.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.