Study of Sintering Behavior of Methane Hydrate Particles on the Wall Surface.

Abstract

The sintering of hydrate aggregates on the pipe wall is a major form of hydrate deposition. Understanding the sintering behavior of hydrates on the wall is crucial for promoting hydrate safety management and preventing pipeline blockage. However, limited research currently exists on this topic. In this study, the cohesive force strength of hydrate particles on the wall surface under different conditions was directly measured using a high-pressure micromechanical force device (HP-MMF). Subsequently, the effects of subcooling and glycine on the cohesive force were investigated. The results indicate that the cohesive force is influenced by different growth states during the process of free water on the wall surface gradually growing into hydrate. Three states with larger measured values during the growth process were selected for research. Observation showed that increased subcooling strengthened sintering by accelerating the growth rate of the hydrate film, resulting in a significant increase in cohesive force. The role of glycine in the methane hydrate system was then evaluated. Glycine was found to reduce the degree of sintering by reducing the growth rate of the hydrate film, thereby decreasing the cohesive force. The optimal concentration in the system was determined to be 0.25 wt %. Moreover, compared with low subcooling (1 °C), glycine had a better effect at high subcooling (5 °C). At 5 °C subcooling and the optimal concentration, the cohesive force in the wall droplet state decreases from 677.38 to 489.02 mN/m, the cohesive force at the low-saturation state decreases from 951.79 to 543.32 mN/m, and the cohesive force at the high-saturation state decreases from 1194.95 to 641.76 mN/m. These findings contribute to a better understanding of the cohesive force behavior of gas hydrate on the inner wall of the pipeline and provide basic data for reducing the risk of hydrate blockage.