Abstract
A blower using the thermal edge flow was proposed, which consists of thin plates in which there are several cuts and the one side of each cut is rounded, and one-way flow is realized. This blower was shown to promote the freeze-drying process in a low-pressure environment. Using a freeze-drying equipment which has a cold trap and heating plate that supplies the latent heat to materials, several sponge blocks and chemical powder were frozen and dried, and the drying time was shortened to almost a half by this blower.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
