Study of PE and iPP orientations on the surface of carbon nanotubes by using molecular dynamic simulations

Abstract

In this study, the early stage of interfacial crystallisation behaviour of low molecular weight polyethylene (PE) and isotactic polypropylene (iPP) oligomer on the surface of carbon nanotubes (CNTs) with different diameters, chiralities and topography structures was studied using MD simulations. We started to simulate the effect of CNTs chirality and diameter on PE molecular chain orientation, and then the effect of CNTs topography structure on PE and iPP molecular chain orientation was investigated. Finally, some experiments were carried out to prove the simulated results. Our study shows that for CNTs with a diameter comparable with the radius of gyration (Rg) of a polymer chain, an easy orientation of PE chains along CNTs axis is observed for all the systems of the CNTs with different chiralities due to a geometric confinement effect. For CNTs with a much larger diameter, multiple orientation of PE chains is induced on its surface due to the lattice matching between graphite lattice and PE molecular chains. In this case, the chirality of CNTs dominates the orientation of graphite lattice, which determines the orientation of PE chains arrangement on CNTs surface. More importantly, it was found that the groove structure formed by CNT bundles is very useful for the stabilisation of polymer chain, and thus facilitates the orientation of molecular chain along the long axis of CNTs. As a result, a novel nanohybrid shish–kebab (NHSK) structure with CNTs acting as central shish while polymer lamellae as kebab can be successfully obtained for both PE with zigzag conformation and iPP with helical conformation. This simulation result was well supported by the experimental observation. Our study could provide not only a deep understanding of the origin of the polymer chain orientation on CNTs surface but also the guidance for the preparation of polymer/CNTs nanocomposites with novel NHSK structure.