Abstract
This study aimed to determine the effect of drilling parameters on hole cylindricity and surface roughness in drilling applications on aircraft wings. It was determined that increasing feed rate resulted in poor hole cylindricity and surface roughness. The ideal feed rate for better hole cylindricity is 0.230 mm/rev, while the ideal feed rate for better surface roughness is 0.200 mm/rev. Both hole cylindricity and surface roughness have a minimum correlation with each other in producing a good quality of drilled holes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.