Abstract
Three batches of pure beryllium (Be), pure tungsten (W) and mixed Be:W (50:50) coatings were deposited by using the thermionic vacuum arc (TVA) technique. Different superficial roughness and morphologies were obtained by adjusting the bias voltages in the substrate holder. The coatings were irradiated afterwards with 15keV 2H+ ions up to a fluence of 5e17ion/cm2 with the purpose to investigate the influence of the roughness parameters on the retention of deuterium in Be-W deposits in the absence of other co-deposited impurities. Current densities lower than 0.2W/cm2 were used to avoid the release of deuterium induced by heating loads. The results of the experiment point to the negligible effect of rugosity on the retention behaviour under energetic ion bombardment.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.