Study of Critical Dimensions of Printable Phase Defects Using an Extreme Ultraviolet Microscope

Abstract

We constructed an extreme ultraviolet microscopy (EUVM) system for actinic mask inspection that consists of Schwarzschild optics and an X-ray zooming tube. This system was used to inspect completed extreme ultraviolet lithography (EUVL) masks and Mo/Si coated substrates on ultralow expansion (ULE) glass. We also have fabricated programmed phase defects on the blanks used for inspection. The EUVM system was capable of resolving a programmed line-pit defect with a width of 40 nm and a depth of 10 nm and also that with a width of 70 nm and a depth of 2 nm. However, a 75-nm-wide, 1.5-nm-deep pit defect was not resolved. The EUVM system was also capable of resolving programmed hole-pit defects with widths ranging from 35 to 170 nm and depths ranging from 2.2 to 2.5 nm. However, 20-nm-wide, 1.5-nm-deep hole-pit defects were not resolved. These results agree with the simulation results perfectly. Thus, in this study, critical dimensions of a pit defects on mask blanks were determined to be a width of 20 nm and a depth of 2 nm.