Abstract
Two types of electrical sheet steel M250-35A and M530-50A were used to cut by melting with a TruLaser 1030 technological system. It was observed that pressure of auxiliary gas had a major effect on kerf width b and cut angle deviation α. Nitrogen as an assisted gas has been taken. The basic parameters as laser power, cutting speed, focus position were constantly supported and the pressure was changed from 4 bar to 20 bar by step 2 bar. As well as the experimental results of gas pressure on entrance and exit kerf widths, have been analyzed and discussed in this study.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Environment. Technology. Resources. Proceedings of the International Scientific and Practical Conference
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
